3M Avagard User Manual

Medical and Surgical Requisites Pty Ltd
Call within Brisbane 07 3859 2900 33 Fulcrum Street Richlands Q 4077 PO Box 3965 Mt. Ommaney QLD 4074
Phone 1300medsurg (1300 633 787) Email medical@medsurg.com.au www.medsurg.com.au Fax 07 3859 2995
Your 6 step 3M Avagard dispenser rell guide
Locate release
button at the
base of the unit
Holding new bottle,
place your thumb in
indentation on cap
and remove. Ensure
the collar remains
on around the tip of
the bottle
Press button
while gently
pulling down
front of unit, do
not drop door
Place new
product in
dispenser
Lift out empty
3M
™
Avagard
™
bottle with
collar attached
and dispose of
thoughtfully
Step
One
Step
Four
Step
Two
Step
Five
Step
Three
Step
Six
Gently push
bottle back in
the dispenser
until both bottle
and dispenser
'clicks' into place

3M Avagard Specifications

General

Brand	3M
Model	Avagard
Category	Dispenser
Language	English

Summary

3M Avagard Dispenser Refill Guide

Step 1: Locate Release Button

Locate the release button at the base of the dispenser unit to begin the refill process.

Step 2: Open Dispenser

Press the release button and gently pull down the front of the unit without dropping the door.

Step 3: Remove Empty Bottle

Lift out the empty bottle with the collar attached and dispose of it thoughtfully.

Step 4: Prepare New Bottle

Hold new bottle, place thumb in cap indentation, remove collar from tip.

Step 5: Insert New Product

Place the new product bottle correctly into the dispenser.

Step 6: Secure Dispenser Bottle

Gently push the bottle back into the dispenser until it clicks securely into place.