To Next Page

To Previous Page

3M Touch Systems Technical Note

Product: MicroTouch

™

CT150 Monitor Industrial Bezel – Installation Instructions

4. Inspect the bezel assembly. Confirm the presence and integrity of both gaskets. Confirm the

presence and integrity of 8 threaded studs on the outside diameter of the bezel. Confirm the

presence and integrity of 10ea.- I.D. threaded extensions on the inside diameter of the bezel. See

Figure 2.

Figure 2 – Part identification

5. The bezel is designed such that the frame piece immediately outside of the I.D threaded

extensions pilots on the outside of the monitor frame. Place the bezel “face down” on the

protected work surface with the studs and threaded extensions facing you. Loose-fit the bezel

onto the CT150 monitor by carefully lowering the chassis monitor into the bezel frame. Be

careful not to drop the monitor onto the bezel as damage to the monitor may result.

Note: There is no top or bottom to the bezel - either orientation is correct.

Other manuals for 3M MicroTouch CT150

Questions and Answers:

Need help?

Do you have a question about the 3M MicroTouch CT150 and is the answer not in the manual?

General