Why won't my 3M Peltor AS-MCAS-92 Headsets power on?
If your 3M Headset won't power on, the issue might be drained batteries. Try replacing them. Alternatively, the batteries might be improperly installed; double-check the polarity to ensure they are correctly placed.
What to do if I can hear radio but cannot transmit on my 3M Peltor AS-MCAS-92?
If you can hear radio communications but cannot transmit using your 3M Headsets, here are a few things to try: 1. Ensure the headset plug is fully seated by inserting it into the PTT housing and rotating 180° to rule out a poor connection between the headset and the PTT. 2. If available, swap with a "known good" PTT. If this solves the problem, replace the original PTT. 3. Check the comms microphone connection on the backside of the earcup. If the problem persists, replace the comms microphone with a "known good" microphone. If this solves the problem, replace the comms microphone.
Warning about hearing loss from hazardous noise exposure and misuse of hearing protection.
Failure to follow instructions may result in serious injury or death due to reduced situational awareness.
Failure to follow instructions may reduce protection provided by earmuffs, potentially causing hearing loss.
Step-by-step guide for properly fitting the headset using the headband.
Step-by-step guide for properly fitting the headset using the backband.
Detailed steps for converting the headset from headband to helmet attachment.
To Next Page
General