22
EN
4.4. TO FIT THE RCU-300
1. Pull and lift the locking bracket of the RCU-300 outwards
and upwards.
IMPORTANT! Make sure that the RCU-300 is placed
within arm-length from the SCU-300.
2. Slide the RCU-300 onto the rail system.
IMPORTANT! Make sure that the locking bracket is facing the
barrel.
3. Fold down the locking bracket of the RCU-300.
4. Pull the RCU-300 towards the barrel to lock it into place.
4.5. TO POWER ON THE TEP-300
Note: The TEP-300 power on automatically when removed
from the case. This section applies if TEP-300 has not been
stored in the case or has been powered off for eartip selection
andtting.
1. Press and hold the power/control button for a minimum of
3 seconds.
Beep Beep
Beeeeep
Beeeeep
Beeeeep
Note: The earplugs will indicate that the product is on/off with
a “triple tone” sequence. A longer tone that repeats three times
indicates that the product is not connected to the SCU-300 yet
or that is has lost connection. Refer to “5.3. To connect the
TEP-300 to the SCU-300”.
Note: Beeping sounds only occur if the headset has previously
been paired with the SCU-300.
2. Repeat this process for the other earplug.
Note: If a “squealing” tone is heard emitting from the TEP-300,
it is an indication that the earplug is not properly inserted and
that an airtight seal has not been obtained. The product should
not be used in hazardous noise if a proper eartip seal is not
achieved.
4.6. TO POWER ON THE COMTAC™ VII
MakesuretheComTac™VIIiscorrectlytted.Refertotthe
product in the User Instructions for ComTac™ VII.
1. Press and hold the + button for a minimum of 3 seconds.
2. MakesuretheComTac™VIIiscorrectlytted.Referto
“Tottheproduct”intheUserInstructionsforComTac™VII.
ON ~ 3 sec
OFF ~ 3 sec
The headset will indicate power mode with appropriate audio
message of “Power On” or Power Off”.
Note: A beeping sound indicates the headset is not connected
to the SCU-300. Refer to section “5.4. To connect ComTac™
VII to the SCU-300”.
EN
To Next Page
Loading...