3M PELTOR ComTac 7 - PAIRING AND CONNECTING THE SYSTEM; Pairing RCU-300 to SCU-300

23
4.7. TO POWER ON THE SCU-300
If the SCU-300 was previously connected to the TEP-300 or
ComTac™ VII, the devices will connect automatically when
within range of the SCU-300 and devices are powered on.
1. TheusermustrstemployTEP-300and/ortheComTac™
VII. Refer to the User Instructions of those products for
start-up instructions.
NOTE: The SCU-300 must be positioned correctly during
startup to correctly pair with each device. Refer to “4.3. To
ttheSCU-300”.
2. Press and hold the On/Off/Menu button on the SCU-300
for ~3 seconds.
ON ~ 3 sec
~ 2 secOFF
3. The TEP-300 and/or the ComTac™ VII will indicate
pairing.
• 2 short beeps, indicates a successful pairing to the
SCU-300.
• 3 long beeps, indicates the NFMI link is lost.
Beep Beep
Beeeep Beeeep Beeeep
Note: Beeping sounds only occur if the headset has
previously been paired with the SCU-300.
4. If pairing fails, check proper SCU-300 placement. If
problem persists, press the On/Off/Menu button on the
SCU-300 for ~10 seconds or until 2 short beeps are heard
in TEP-300 and/or the ComTac™ VII.
4.8. TO POWER ON THE RCU-300
1. Short press the + button to power on the RCU-300.
ON
2. Press any button to wake up the RCU-300 if it has gone
into sleep mode.
EN
5. TO PAIR AND CONNECT THE SYSTEM
5.1. TO PAIR THE RCU-300 TO THE SCU-300
RCU-300 uses Bluetooth
®
Low Energy communication.
Bluetooth
®
Low Energy is a short-range wireless
communication protocol. It is designed for long battery life.
Therangeis≈50cm/20in.
Pairing the RCU-300 to the SCU-300 requires the use of the
TEP-300 or ComTac™ VII headset. Refer to those products’
User Instructions for use information.
To receive auditory prompts when powering on the SCU-300,
theusermustrstemploytheComTac™VIIheadsetor
TEP-300 earplugs. If the SCU-300 was previously connected
to the TEP-300 or ComTac™ VII, the devices will connect
automatically when within range of the SCU 300 and devices
are powered on.
1. Power on the TEP-300 and/or ComTac™
VII. Refer to “4.5.
To power on the TEP-300” and/or “4.6. To power on the
ComTac™ VII”.
NOTE: Make sure the TEP-300 and/or ComTac™
VII are
correctlytted.RefertototheUserInstructionsforthose
products.
2. Power on SCU-300. Refer to “4.7. To power on the
SCU-300”.
3. Power on the RCU-300. Refer to “4.8. To power on the
RCU-300”.
4. Short press the power button on the SCU-300 to access
the menu.
~ 0.5 sec
5. Short press the - button to move forward in the menu
system until the audio message indicates the “Advanced
settings” sub menu.
6. Select “Advanced settings” with the + button.
EN