3M PELTOR ComTac 7 - Pairing SCU-300 with Bluetooth Device; Connecting TEP-300 to SCU-300

24
7.
Radio
Volume
Ambient
Listening
Advanced
Settings
Short press the - button to move forward in the sub-menu
system until the audio message indicates “Primary RCU
pairing”.
8. Select “Primary RCU pairing” with the + button.
9. Press and hold the PTT II button and - button on the same
time on the RCU-300.
10. While pressing the buttons on the RCU-300, hold the
RCU-300 against the SCU-300 to pair.
11. An audio message will indicate Primary/Secondary RCU
connected.
Note: Select Secondary RCU pairing and repeat the steps to
pair a second RCU-300.
Note: To reset the RCU-300, press and hold the + and -
button on the RCU-300 for 10 seconds.
5.2. TO PAIR THE SCU-300 WITH A
BLUETOOTH
®
DEVICE**
Bluetooth
®
is a wireless technology standard for exchanging
databetweenxedandmobiledevicesovershortdistances.
1. Enable Bluetooth
®
on your mobile device. Refer to the
User Instructions for the mobile device.
2. Press and hold the Function button on the SCU-300.
~ 3 sec
Note: When Bluetooth
®
is enabled on your mobile device, it
should automatically begin a search for Bluetooth
®
devices with
which to connect. When the search has completed, a list of
devices you can connect to will appear on the screen. Select
“SCU” on your mobile device.
5.3. TO CONNECT THE TEP-300 TO THE
SCU-300
The TEP-300 connects to the SCU-300 using Near Field
Magnetic Induction (NFMI). NFMI is a short range wireless
physical layer that communicates by coupling a tight, low-power,
non-propagatingmagneticeldbetweendevices.Therangeis≈
50 cm/20 in. NFMI systems are designed to contain
transmissionenergywithinthelocalizedmagneticeldandthe
energy does not radiate into free space.
If previously connected with the SCU-300, the TEP-300 will
connect automatically when within range of the SCU-300.
The earplugs indicate that the product is connected to the
SCU-300 with 2 short beeps. For more information refer to User
Instructions for 3M™ PELTOR™ Tactical Modular Audio System.
Note: If not previously connected to the SCU-300, the TEP-300
must be paired manually. Refer to “5.3.1. To connect the
TEP-300totheSCU-300forthersttime”.
1. Fit the earplugs.
NOTE: MakesurethattheTEP-300iscorrectlytted.Refer
to the User Instructions for TEP-300.
2. Power on the TEP-300. Refer to “4.5. To power on the
TEP-300”.
3. Press the On/Off/Menu button on the SCU-300 for ~2 seconds.
Note: Beeping sounds only occur if the TEP-300 has previously
been paired with the SCU-300.
The TEP-300 will indicate pairing.
• 2 short beeps, indicates a successful pairing to the
SCU-300.
• 3 long beeps, indicates the NFMI link is lost.
EN
EN
**These features are only are available in SCU-300NA WS GE AND SCU-300EUWS GE.