9
The headset is tested and CE approved as a hearing protector in accordance with the PPE directive 89/686/EC and the
European standards EN 352-1:2002, EN 352-3:2002, EN 352-4:2001, EN 352-6:2002 and EN 352-8.
Certied by FIOH, Topeliuksenkatu 41, FI-00250 Helsinki, Finland (Notied Body number 0403).
:
1. Frequency (Hz)
2. Average attenuation (dB)
3. Standard deviation (dB)
4. Expected deviation (dB)
A list of possible headset/helmet combinations can be found in appendix .
The sound output from the speakers inside the cups may exceed the permitted exposure level. The audio
signal must be adjusted to suit the exposure time. To prevent harmful effects, the input signal should not exceed 30 mV.
At a higher input voltage, the operating time must be decreased according to diagram E:1 (x=30 mV). An electrical input
signal of 30 mV(RMS) corresponds to 82 dB (A) equivalent sound level (average value plus one standard deviation of the
measured sound level. See table E:2). The maximum output effect of the earphones must not be exceeded.
Bluetooth 2.1 + EDR
A2DP 1.2
HSP 1.5
HFP 1.5
EN 300 296-2 V1.2.1 (2009-02)
EN 300 328 V1.7.1 (2006-10)
EN 301 489-1 V1.8.1 (2008-04)
EN 301 489-5 V1.3.2 (2008-04)
EN 301 489-17 V1.3.2 (2008-04)
EN 60950: 2006
The measurements were performed by BACL, Shenzhen, Guangdong, China
EN60950:2006 Low Voltage Directive + amendment A11:2009
The measurements were performed by Timeway Testing Laboratory, Hong Kong
3M Svenska AB hereby declares that this WS Peltor Lite-Com is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. See also full copy of Declaration of Conformity on page .
To Next Page
Loading...
Need help?
General
