5
Safety information for the R-Series Model 8410
WARNING
To reduce the risk associated with fire due to modification or incorrect
installation of system components or the use of non-approved replacement
components:
Do not attempt to modify or repair—no user serviceable parts—contact 3M Service
for repair.
Use approved system components installed by 3M service personnel only.
Install system components into desk or enclosure according to instructions and
specifications given in the Model 8410 Site Planning Guide.
To reduce the risk associated with hazardous voltage due to a user attempting
to service a component, incorrect installation of system components, or use of
the system when damage has occurred:
Do not attempt to modify or repair—no user serviceable parts—contact 3M
Service for repair.
Install system components into desk or enclosure according to instructions and
specifications given in the Model 8410 Site Planning Guide.
Do not use the interconnect box, appliance coupler, or computer if any cases or
power cords are damaged.
CAUTION
To reduce the risk associated with environmental contamination due to the
incorrect disposal of the lithium battery in PC, mercury in monitor/display,
and/or any circuitry that contains lead in the solder:
At the end of service life, dispose of interconnect box, appliance coupler, PC,
monitor, and laser scanner in accordance with federal, state and local
requirements.
To reduce the risk associated with exposure to laser light due to a person
looking into the laser scanner:
Do not look directly into laser scanner device.
At the end of service life, dispose of laser scanner in accordance with federal,
state, and local requirements.
IMPORTANT NOTE
The Code of Federal Regulations (CFR) 21CFR1040.10 requires the following
statement for products containing lasers:
Caution—use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous laser light exposure.
To Next Page
Loading...