54
Basic Operations
Install two 1.5V AA batteries as shown.
Close battery door until it clicks.
Press and hold the On/O/Volume
button for 2 seconds to power
headset. Turn On/O/Volume knob
clockwise to control volume.
Installing Batteries: Power and Volume:
Fully extend sliders and place cups
over ears so that the microphones
are facing forward. Then, tighten
headband using sliders.
For improved comfort, insert the Comfort
Pad into the headband holes from below
with the textured cushion facing down.
To remove the padding, simply hold the
headband securely, and push down on
the headband padding.
Fitting Headset: Headband Padding:
To Next Page
Loading...
