3. Record serial numbers of the three components
• Orient the three components in the manner illustrated below to reveal the component’s serial number – highlighted in
yellow on each component.
3. Follow the procedure to disassemble the XT-1 Headset and record it’s serial number
• Remove the ear cup off the headset speaker
-- Remove the ear pad by using your fingers to pull
the ear pad from the ear cup.
-- Then grasp the headset firmly in one hand, and pull
the ear cup off the speaker with the fingers of the
other hand.
• Record serial numbers of the headset
G5 Carrier G5 Control Pod
G5 Battery
3M is a trademark of 3M. Used under license in Canada
Please recycle. Printed in USA.
© 3M 2016. All rights reserved.
Commercial Solutions Division
3M Center, Building 223-2N-21
St. Paul, MN 55144-1000
www.3M.com/drivethru
To Previous Page
Loading...
