tm
MyoLift Mini Device Maintenance:
Make sure the device is disconnected from the wall socket and the probe
applicators are disconnected from the device
Remove all foreign matter from device and probes with wet paper towel.
With gloves on, spray state approved disinfectant onto wet paper towel and
wipe down the device and probes thoroughly.
With a second paper towel, wet with water only, wipe down the device and
probes thoroughly.
Allow a few minutes to air dry.
Disinfecting Protocol:
Storing the Device and Probes
Store the probes in a closed container or bag.
Warning
Keep wires loosely wound, as to not cause breakage.
DO NOT IMMERSE probes into disinfectant solution.
18
To Next Page