16
Hardware Operation
© 2020 7thSense Design
Back / Rear Panel Connections
Delta NanoR
Delta Pico
Pico low voltage power supply unit
The Pico is certified for use with the 19 V power unit supplied by 7thSense, rated at 100-240 VAC ~ 3-1.5 A, 60-
50 Hz. The operating voltage for Pico is 12-19 VDC.
Pico NIC
On the rear right-hand side, the RJ45 port labelled ‘NIC 1’ is factory-set to a static IP and ‘NIC 2’ to DHCP. A
label with this initial static IP address is provided on each unit.
Pico GPIO
GPIO inputs and outputs are set by Delta External Controls, which are listed in DeltaGUI > Help > External
Control, under GPIO Commands:
To Next Page
Loading...