The Card browser is a utility in the WebUI that allows you to
view, manage and load your VMCs remotely.
When you visit the Card Browser for the first time, you will be
greeted with just the default memory card that were created
when you booted up the device for the first time.
To refresh the card contents, press the blue “Scan” button. The
MemCard PRO2 will start scanning your storage device for
VMCs and it will add them to the Card Browser. This only needs
to be done once.
Once scanning is complete, the table will show the available
VMCs on your microSD card.
You can switch between systems by flipping the PS1/PS2
switch. Each list is shown separately. Mounting a VMC from a
specific system will switch the mode to that system
automatically.
You can now create a new VMC, rename your VMCs, mount
them remotely or delete them. If you use an home-brew
launcher or ODE, the VMC will be added to this list
automatically.
To Next Page
Loading...