EasyManua.ls Logo

A.J.Antunes VCT-250 User Manual

A.J.Antunes VCT-250
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Rapid toasteR VCt-250
1
P/N 1010837 Rev. L 03/07
McDonald’s
RAPID TOASTER
MODEL VCT-250
Manufacturing Numbers 9210606, 607, 608, 611, 613, 615, 616, 624 & 626
0/7%2
4%-0
$/7.
4%-0
50
4%-0
3#!,%
#
&
CAUTION
Place this manual in the Toaster section
of your Equipment Manual.
Manufactured exclusively for
McDONALD’S
®
BY
A.J. ANTUNES & CO.
180 KEHOE BLVD.
CAROL STREAM, ILLINOIS 60188, U.S.A.
PHONE: 1-630-784-1000
TOLL FREE: 1-877-392-7854
FAX: 1-630-784-1650
www.ajantunes.com
TABLE OF CONTENTS
This manual is for the exclusive use of licensees and employees of McDonald’s Systems, Inc.. © McDonald’s Corporation All Rights
Reserved
LIMITED WARRANTY
The Antunes Food Service Equipment Division of A.J. Antunes & Co. provides the following limited warranty to the original purchaser of all McDonald’s Equipment.
All components are warranted against defects in the material and workmanship for a period of two (2) years from date of original installation, not to exceed 30 months
from date of shipment from our factory.
If any part becomes defective during the first two (2) years after the original installation date, Antunes Food Service will pay negotiated straight time labor costs to an
Authorized Service Agent to replace the part, plus travel expenses up to 50 miles/80 km, 1 hour each way (100 miles/160 km, 2 hours round trip).
Antunes Food Service reserves the right to make changes in design or add improvements on any products. The right is always reserved to modify Equipment
because of factors beyond our control and government regulation. Changes to Equipment do not constitute a warranty charge.
This warranty is exclusive and is in lieu of all other warranties, expressed or implied, including any implied warranty of merchantability or fitness for a particular pur-
pose, each of which is expressly disclaimed. The remedies described above are exclusive, and in no event shall A.J. Antunes & Co. or any of its Divisions be liable
for special consequential or incidental damages for the breach or delay in the performance of this warranty.
WARRANTY EXCLUSIONS
The cost of Installation.
Equipment that has been damaged due to shipment. Purchaser should
make damage claim directly upon carrier.
Alteration, misuse, abuse.
Improper storage or handling.
Improper maintenance.
Failure to follow proper Installation instructions, including electrical connec
-
tion.
Improper or unauthorized repairs.
Scheduled Maintenance procedures as outlined in your MRC Card.
Consumables such as Grill Covers (Release Sheets), gaskets, Conveyor Belt
Wraps, O-Rings, and light bulbs.
Overtime or Holiday charges.
Mileage over 50 miles/80 km (100 miles/160 km round-trip), or travel time
over two (2) hours.
Fright, foreign, excise, municipal or other sales or use taxes.
Consequential damages such as loss of profit, loss of time, the cost of repair
-
ing or replacing other property which is damaged, or any other incidental
damage of any kind.
Owner Information .....................................................2
General ......................................................................2
Warranty Information .................................................2
Specifications .............................................................2
Model Specifications ..................................................2
Electrical Cord & Plug Configurations .......................2
Dimensions ................................................................3
Weights ......................................................................3
Important Safety Information ....................................4
Installation ...................................................................5
Unpacking ..................................................................5
Assembling the Unit ..................................................5
Location .....................................................................5
Operation .....................................................................
6
Operating Instructions ...............................................6
Toaster Operation ......................................................7
Safety Features .........................................................8
Maintenance ..............................................................10
Daily cleaning ..........................................................10
Measure the Conveyor Belt Chains for Stretch ......12
Replacing Belt Wraps .............................................13
Checking the Temperature of the Bun Landing Area 14
Adjusting, Measuring and/or Replacing Roller
Tensioner Assemblies ..............................................14
Troubleshooting .......................................................15
Replacement Parts ..................................................18
Wiring Diagrams .......................................................23
Service/Technical Assistance .................................24
A
S
D
L
I
S
T
E
CM
O
I
N
N
I
T
A
T
Testing & Certification
ITS
geprufte
Sicherheit
Question and Answer IconNeed help?

Do you have a question about the A.J.Antunes VCT-250 and is the answer not in the manual?

A.J.Antunes VCT-250 Specifications

General IconGeneral
BrandA.J.Antunes
ModelVCT-250
CategoryToaster
LanguageEnglish

Summary

LIMITED WARRANTY

SERVICE/TECHNICAL ASSISTANCE

Obtaining Technical Support

Provides contact information and procedures for obtaining technical assistance and service for the unit.

IMPORTANT SAFETY INFORMATION

General Warnings and Cautions

Highlights general warnings and cautions regarding equipment operation and potential hazards.

Electrical and Hot Surface Safety

Details electrical shock hazards and hot surface warnings for safe operation.

Safe Operation Guidelines

Provides essential guidelines for safe operation, including grounding, cord handling, and maintenance.

INSTALLATION GUIDE

OPERATION

Toaster Operating Procedure

Outlines the step-by-step process for operating the toaster, including warm-up and toasting.

OPERATION (continued)

Temperature Control and Adjustment

Details how to control and adjust platen and auxiliary heater temperatures for optimal performance.

Additional Fault Message Explanations

Explains "CHEC", "PO", and "PH" fault messages and their corresponding troubleshooting steps.

Platen Setpoint Temperature Adjustment

Provides detailed steps for adjusting the platen setpoint temperature.

Safety Features and Hi-Limit Reset

Describes the hi-limit control and how to reset it if the unit overheats.

Understanding Fault Messages

Details common fault messages displayed by the unit and their potential causes.

MAINTENANCE

MAINTENANCE (continued)

TROUBLESHOOTING

No Display or Power Light Issues

Addresses issues with the unit having no display or the power switch light not illuminating.

Temperature Display Faults

Explains various temperature display faults like "PH", "PO", and "LO" messages.

Overheating and Diagnostic Indicators

Covers overheating faults ("HI" messages) and ambient temperature issues ("CHEC").

TROUBLESHOOTING (continued)

Toasting Temperature and Time Adjustments

Addresses issues related to over-toasting, under-toasting, and incorrect drop times.

WIRING DIAGRAMS

Related product manuals