NEED HELP? GIVE US A CALL 877.333.7108
INSTALLATION GUIDE
5
1. Pick an appropriate installation location. Unit must be installed in an area where
the main water line enters your home, before connecting to the water heater.
Note: DO NOT install after the water heater or on the hot water line.
Components and installation will vary.
2. Turn off the main water source prior to installation and drain water from lines.
3. Wrap your 3/4" male NPT ttings with NSF certied plumber’s tape. Connect
the 3/4" male ttings to the system’s inlet and outlet.
Note: DO NOT use pipe solvent (dope), as solvents in some types of pipe dope
may cause damage to plastic ttings. Do not over-tighten to prevent damage to
lter head.
1. Using a pipe cutter, cut into the main water supply line to install the shut-off valve.
2. Loosely t shut-off valve to calculate proper spacing of components.
3. Measure distance for lter head and mark pipe accordingly.
Note: If you’re also installing a bypass loop, do so at this time.
Ensure proper spacing
to t lter head
Shut-off Valve
Incoming
water supply
Outgoing
water supply
STEP 2 Prepare for Installation
STEP 3 Install Shut-Off Valve
To Next Page
Loading...
Need help?
General
