Why is there no hot water from my A.O. Smith EWJH 15?
If your A.O. Smith Water Heater isn't producing hot water, it could be due to a couple of reasons. First, check the power socket to ensure there is a power supply. If the power socket is working, there may be a control circuit or internal wiring error, which requires professional assistance. In this case, you should call Customer Care Centre.
What to do if my A.O. Smith Water Heater is leaking?
If you notice water leaking from your A.O. Smith Water Heater, it could indicate a leakage in the tank or other parts. Immediately shut off the power and contact Customer Care Centre for assistance.
Why is the water temperature too high in my A.O. Smith EWJH 15?
If the water temperature from your A.O. Smith Water Heater is too high, it may be due to damaged electronics circuit. Call Customer Care Centre for assistance.
Why does my A.O. Smith Water Heater display but provides no hot water?
If your A.O. Smith Water Heater has a display but isn't producing hot water, it could be due to heating element breakdown or an internal wiring error. In this case, you should call Customer Care Centre.
How to fix piping connection leaks on A.O. Smith Water Heater?
If you're experiencing leaks at the piping connections of your A.O. Smith Water Heater, it's likely that the connection isn't properly sealed. Re-connect the piping, making sure to use tape thread sealant.
What does error code E5 mean on A.O. Smith EWJH 15 Water Heater?
If your A.O. Smith Water Heater's wired remote controller displays error code “E5”, it indicates a low voltage protection issue (voltage >100 V &
What does error code E4 on A.O. Smith EWJH 15 mean?
If the wired remote controller of your A.O. Smith Water Heater shows error code “E4”, it indicates a current leakage detection circuit fault. The suggested solution is to call Customer Care Centre.
What does error code E3 on A.O. Smith EWJH 15 remote mean?
If your A.O. Smith Water Heater wired remote controller displays error code “E3”, it indicates extra high temperature. The suggested solution is to call Customer Care Centre.
What does error code E1 mean on A.O. Smith EWJH 15 controller?
If your A.O. Smith Water Heater wired remote controller displays error code “E1”, it signifies a temperature sensor circuit short or open. The suggested solution is to call Customer Care Centre.
What does error code E0 on A.O. Smith EWJH 15 mean?
If the wired remote controller of your A.O. Smith Water Heater is displaying error code “E0”, it indicates a leakage of electricity. The suggested solution is to call Customer Care Centre.
Details the functionality of the wired remote for control.
Instructions and diagrams for mounting the water heater on the wall.
Details on plumbing, making connections, and sealing.
Guidelines for making safe and correct electrical connections.
Guide to setting the desired water temperature.
General| Type | Electric Water Heater |
|---|---|
| Capacity | 15 liters |
| Power Consumption | 2000 Watts |
| Frequency | 50 Hz |
| Thermostat | Adjustable Thermostat |
| Warranty | 2 years |
To Next Page