24page
• Tyre pressure. Your A2B features heavy duty in-
ner tubes to help avoid at tyres. However, bicycle
tyres normally lose pressure over time. An under
inated tyre can cause premature tyre failure, and
will require signicantly more energy (electric and
human) to propel your A2B . Low tyre pressure
will signicantly reduce the range under electric
power. The recommended tyre pressure for the
front wheel and rear wheel is 2.8 bar (40 psi).
• Quick release. Make sure that your front
wheel quick release is properly adjusted and
tight. Failure to properly adjust and lock your front
wheel quick release may result in the wheel fal-
ling off while riding which could result in serious
or fatal injury and/or and/or property damage. If
you are uncertain about any aspect of the assem-
bly and adjustment of your A2B , ask your A2B
dealer.
• Handle bar and steering. Please ensure, that
the bolts of the handle bar (see 3.5) and of the
bar stem (see 3.6) are tightened with the correct
torque. The 2 allen screws for the handle bar
clamp have to be tightened with 5 Nm torque.
• Battery. Check the display prior to setting off
on your journey to ensure the battery has enough
charge to easily last your journey.
If you don’t understand any aspect of the
assembly, use and care of your A2B , please ask
your A2B dealer.
To Next Page
