2
1. Hardware Installation
1). Connect the Multi-link receiver
Take out the Multi-link receiver from bottom of the mouse and connect it to your computer.
2). Insert the batteries
Open the battery cover and insert the supplied batteries.
Note: Make sure the positive (+) and negative (-) ends of the battery match the polarity indicators inside the
battery compartment.
3). Turn on your Mouse
Push the power switch to ON position and turn on your mouse. >>Then LED light at the bottom of the mouse
is on immediately.
4). Position the wireless mouse and Multi-link receiver within 15m operating range (Note: The actual distance
depends on the environment.)
Note: For more functions such as RF Channel Lock, Gesture 16-in-1, 4-way Wheel and so on, please install
the G9 16-in-1(enclosed in the CD) software first!
To Next Page
Loading...
