HL
HLHL
HL-
--
-i series Digital Compact Scale
series Digital Compact Scale series Digital Compact Scale
series Digital Compact Scale
Operating Instructions
Operating Instructions Operating Instructions
Operating Instructions
Cautions
CautionsCautions
Cautions
G Avoid installing the scale in direct sunlight.
G Avoid over / shock load that could cause damage to the scale.
G
Use the scale under conditions of -10°C to 40°C, less than 85% R.H.
G
The weighing pan cannot be removed. Do not pull on up it.
G Do not mix the battery types. Replace all of the batteries at same time.
G If the scale is not to be used for a long period of time, remove the all batteries.
G Use only the specified AC adapter for the scale (AC adapter is optional).
Specifications
SpecificationsSpecifications
Specifications
HL-200i 200 x 0.1 g / 7.05 x 0.01 oz / 1000.0 x 0.5 ct / 5.335 x 0.005 tl
HL-2000i 2000 x 1 g / 70.5 x 0.1 oz / 4 lb 6.6 oz x 0.1 oz / 53.35 x 0.05 tl
Power 4 x “AA” size batteries (monitor batteries included) or AC adapter
Battery life Approximately 1000 hours with alkaline cells at 20°C / 68°F
Pan size 130 mm / 5.1 in.
Dimensions 130 (W) x 192 (D) x 51 (H) mm / 5.1 (W) x 7.6 (D) x 2.0 (H) in
Keys and Symbols
ON:OFF key Turns the scale power on/off.
RE-ZERO key Sets the display to zero.
UNITS key Changes weighing units.
Symbol STABLE £ Indicates when the reading is stable.
Symbol ZERO
! Indicates when the scale zero is correct.
Installing batteries / Connecting the AC adapter
Installing batteries / Connecting the AC adapter Installing batteries / Connecting the AC adapter
Installing batteries / Connecting the AC adapter
Installing / Replacing Batteries
Installing / Replacing BatteriesInstalling / Replacing Batteries
Installing / Replacing Batteries
Remove the battery cover and insert 4 batteries (AA size)
into the battery housing, especially take care of the
polarities. Attach the battery cover again.
AC adapter (optional)
AC adapter (optional)AC adapter (optional)
AC adapter (optional)
Peel off the seal on the battery cover to thread the
AC adapter wire through. Plug the AC adapter to
the AC adapter jack inside the battery housing.
Attach the battery cover again.
Peel off the seal here
Battery cover
AC adapter jac
To Next Page
Need help?
General
