Need help?Do you have a question about the AAON CommLink 5 and is the answer not in the manual?
General| Brand | AAON |
|---|---|
| Model | CommLink 5 |
| Category | Recording Equipment |
| Language | English |
Describes the CommLink 5's function for system communications and computer interface.
Details the IP Module Kit for TCP/IP Internet/intranet connections and its components.
Provides instructions for installing the CommLink 5 without a computer or IP module.
Lists essential hardware and software for programming CommLink 5 with Prism 2.
Lists optional components for advanced connectivity like LAN and Internet.
Step-by-step instructions to get the CommLink 5 operational quickly.
Key considerations for installation, configuration, and troubleshooting.
Illustrates and describes physical connections for Ethernet, USB, and power.
Critical warnings about IP module use, terminal polarity, and wiring standards.
Explains how to set the Loop switch for different system configurations (Single/Multiple).
Details when to set the Loop switch to "Multiple" or "Single".
Explains how to set the Baud rate switch for optimal performance based on controller types.
Details when to set the Baud rate switch to "High" or "Low".
Guides through installing necessary USB drivers for PC communication.
Instructs on choosing between 32-bit and 64-bit drivers based on the OS.
Describes how to find the assigned COM port number in Windows Device Manager.
Explains how to identify the correct COM port for Prism 2 setup.
Step-by-step guide for configuring the CommLink 5 within the Prism 2 software.
Explains selecting the correct network configuration type in Prism 2.
Details how to search for installed units after configuration in Prism 2.
Guides on using the "Search for Units" window for automatic controller detection.
Provides steps if "Units Found on this Loop" remains zero after searching.
Explains the function of each LED indicator on the CommLink 5 device.
Details the meaning of LOOP, TX-USB, RX-USB, and COMP LEDs.
Details the meaning of ACT-LAN, LNK-LAN, and WLAN LEDs.
Discusses network configurations involving firewalls and proxies for connectivity.
Illustrates a typical network setup with a firewall/proxy configuration.
Lists common issues and solutions related to Prism 2 software setup.
Provides troubleshooting steps for USB connection failures.
Offers solutions for issues when viewing multiple controllers on the network.
Explains why and how to change the COM port number if it's 10 or greater.
Details how to access and modify COM port settings in Windows.
Guides on choosing an available COM port number less than 10.
To Next Page