Aastra 7187a - Speed Dial Memory

Aastra 7187a Analogue Telephone 23
Area Code Filter
If area code was set (see “Area code setting”), the phone will compare and
filter the initial digits of the incoming number
.
An example:
The area code was set “755”.
If the incoming call’s number is “755-12345678”, then caller ID will be
displayed “12345678” while “755” will be filtered.
Note: Only numbers with 7 digits or longer could be filtered the area code.
Otherwise the complete number with area code will be displayed
Speed Dial Memory
There are seven keys (M1-M7) for storing frequently used number. You
can store two numbers per key by using (shift+M1-M7)
Save a Memory
1. Replace the handset on the phone
2. Press memory key (M1 to M7) or “second level” memory keys
(Shift + M1 to M7)
3. Press
and enter the name to be saved
4. Press
and enter the number to be saved
5. Press
key again to complete saving
Note: For some rare conditions it may be useful to insert a pause between
e.g. the area code and the phone number. To do this; enter the area code,
press the pause key and then continue with the telephone number.
Protect All Memories
It is possible to set a password in the telephone for speed dial and phone
book entries. Please see “Set Password” found below under the
paragraph for “Phone setting”.
Dial from a Memory key
1. Pick up the handset or press
2. Press memory key (M1 to M7) or “second level” memory keys
(Shift + M1 to M7) to be dialed