30
Set Password
The activation of the memory protection lock in the telephone is done in two
steps: First a four (4) digit password is defined by the user. Then the lock
state must be selected.
1. Press
> PHONE SETTING > SET PASSWORD
2. Press numeric keys to input the OLD password (default – ‘0000’)
3. Press
or to confirm the OLD password
4. Press numeric keys to input the NEW password
5. Press
or to confirm the NEW password
6. Enter the NEW password again for reconfirmation
7. Press
or to complete the setting
Set Lock state
The lock state protects the content of the phone book and speed dial
memories. It is possible to lock and unlock the memory protection function
1. Press
> PHONE SETTING > SET LOCK STATE
2. When the display shows “ENTER PASSWORD”, enter the password
If the phone was locked:
1. The display shows “UNLOCK?”
2. Press
or to unlock / Press or to quit without change
If the phone was unlocked (default):
1. The display shows “LOCK?”
2. Press
or to lock / Press or to quit without change
Note: The phone was default unlocked. While the state is changed to
‘LOCK’, you need to enter password for deleting the calls record and
phonebook or to change the settings which are lock protected (see “Menu
Operation”)
LCD Contrast
1. Press > PHONE SETTING > LCD CONTRAST
2. Press or to adjust the display contrast
3. Press
or to confirm
To Next Page
Loading...
