AB IPBOX
User manual
4
Caution: Hot surface. Do not touch. The top surface over the internal heat
sink may become hot when operating this product continuously.
Do not touch hot areas, especially around the ‘Hot surface mark’ and the top
panel.
When this logo is attached to a product, it means a financial contribution has
been paid to the associated national recovery and recycling system.
To avoid electric-shock hazards, do not open the housing, refer servicing to
qualified personnel only.
Do not expose the receiver to direct sunlight. Keep it away from the heat
source.
When the abnormal phenomenon occurs, you should cut off the power supply
immediately
Switch the receiver off whenever it remains out of service for an extended
period.
Keep the receiver away from flower vases, tubs, sinks, etc., in order to avoid
damaging the equipment.
Do not block ventilation holes of the receiver so air can circulate freely.
Do not touch the receiver during thunder, since that might create electric-
shock hazards.
It is recommended to cut off power supply.
Be sure to turn the receiver off and disconnect the AC power cord before
cleaning the receiver surface. If the surface is dirty,
wipe clean with a wetted cloth and wrung out thoroughly, then wipe again with
a dry cloth
To Next Page
Loading...
