Function name Signal type Signal name Description
DNPFREC.1.Sig40 Magnitude
at trig
Magnitude at trig
Binary outputs DNPFREC.1.Get first
disturbance
Get first disturbance
DNPFREC.1.Get next
disturbance
Get next disturbance
DNPFREC.1.Get previous
disturbance
Get previous disturbance
Communication logic for
residual OC (RESCPSCH)
Binary inputs RESCPSCH.1.CS Carrier Send by
Communication Scheme Logic
RESCPSCH.1.LCG Loss of carrier guard signal
output from communication
scheme logic
RESCPSCH.1.PRORX Teleprotection signal received
for a forward fault
RESCPSCH.1.OPERATE Trip by communication scheme
logic
Current reversal and WEI logic
for residual OC (RCRWPSCH)
Binary inputs RCRWPSCH.1.CR POR Carrier signal received
from remote end
RCRWPSCH.1.ECHO Carrier send by WEI logic
RCRWPSCH.1.OPR_WEI Operation of WEI logic
Non-directional earth-fault
protection, instantaneous stage
(EFIPTOC)
Binary inputs EFIPTOC.1.OPERATE Operated
EFIPTOC.1.START Started
Non-directional earth-fault
protection, high stage
(EFHPTOC)
Binary inputs EFHPTOC.1.OPERATE Operated
EFHPTOC.1.START Started
Non-directional earth fault
protection, low stage
(EFLPTOC)
Binary inputs EFLPTOC.1.OPERATE Operated
EFLPTOC.1.START Started
Directional earth fault
protection, high stage
(DEFHPDEF)
Binary inputs DEFHPDEF.1.OPERATE Operated signal
DEFHPDEF.1.START Started signal
DEFHPDEF.1.FAULT_DIR Detected fault direction
Directional earth fault
protection, low stage
(DEFLPDEF)
Binary inputs DEFLPDEF.1.OPERATE Operated signal
DEFLPDEF.1.START Started signal
DEFLPDEF.1.FAULT_DIR Detected fault direction
Distance protection (DSTPDIS) Analog inputs DSTPDIS.1.DIR_E_FLT Earth-fault direction (low imp.
earthed), GFC
DSTPDIS.1.CONFLICT_Z1 Tilt angle validity check, Zone Z1
DSTPDIS.1.CONFLICT_Z2 Tilt angle validity check, Zone Z2
DSTPDIS.1.CONFLICT_Z3 Tilt angle validity check, Zone Z3
Table continues on next page
1MRS756791 A Section 2
DNP3 data mappings
630 series 19
Point List Manual
To Next Page
Loading...
