70 CoriolisMaster FCB400, FCH400 CORIOLIS MASS FLOWMETER | CI/FCB400/FCH400-EN REV. H
… 6 Electrical connections
… Digital communication
Ethernet card status LEDs
The 6 LEDs on the Ethernet card indicate the status of each port and the network.
To enable card status indication in the upper HMI Line, navigate to ‘Display / Display Tag / Ethernet Status’.
A Port 1
B Activity 1
C Port 2
D Activity 2
E Module Status (Mod)
F Network Status (Net)
Figure 62: Ethernet card status LEDs
LED Status
HMI displa
Description
A Port 1 ON
Network connection (link up)
OFF
No networ
B Activity 1 Flashing or ON
Traffic
OFF
No traffic
C Port 2 ON
Network connection (link up)
OFF
No networ
D Activity 2 Flashing or ON
Traffic
OFF
No traffic
E Module Status (Mod) green, ON
Mod showing <G> continously Device ready for Operation.
Working properly
green, Flashing (1 Hz)
Mod changing between <G> and < > Standby. Device not configured yet
green/ red, Flashing (1Hz)
Device performs "Power-On" Test
red, Flashing (1 Hz)
Mod changing between <R> and < > Simple Error, which can be fixed
red, ON
Mod showing <R> continously Major Error.
Non removable serious error
OFF
Mod showing < > continously No Power
F Network Status (Net) green, ON
Net showing <G> continously Connected. Device has at least one
established connection
green, Flashing (1 Hz)
Net changing between <G> and < > No Connection.
Device did not establish any connections,
but was assigned an IP address
green/ red, Flashing (1Hz)
Device performs "Power-On" Test
red, ON
Net showing <R> continously Dublicated IP address. Device has detected
that the device IP address is already in use
OFF
Net showing < > continously No supply voltage or IP Address.
red, flashing (1 Hz)
Mod changing between <R> and < > Connection timeout
To Next Page
Loading...
