Need help?Do you have a question about the ABB COPA-XE and is the answer not in the manual?
General| Brand | ABB |
|---|---|
| Model | COPA-XE |
| Category | Measuring Instruments |
| Language | English |
Describes the operation of Electromagnetic Flowmeters (EMF) and their applications in various industries.
Explains data entry using magnet stick or keypad, with notes on plausibility checks and housing opening.
Provides step-by-step instructions for direct numeric entry and table entry of parameters.
Details various parameters and their entry types, including Program Protection, Language, and Submenu Primary.
Explains how to turn program protection on/off, including procedures for factory settings and custom codes.
Explains how to adjust the system zero at the converter, either manually or automatically.
Lists error codes, their detected system errors, and corresponding corrective measures.
Describes essential grounding procedures for the flowmeter primary to meet EMC requirements and ensure equal ground potential.
Shows connection variations for analog and digital communication, including HART, Profibus, and ASCII protocols.
Outlines initial checks for COPA-XE and MAG-XE flowmeters before and after power-up.
Explains how to check and adjust the system zero for the flowmeter, using manual or automatic methods.
Defines the continuous flow range for the converter, from 0.5 to 10 m/s.
Specifies the accuracy of the system as <0.5% of rate.
Provides an overview of settable parameters, their descriptions, and setting ranges.
To Next Page