Operation Manual / 4 Product description / A100-L
Page 89 /
© Copyright 2016 ABB. All rights reserved.
1. Position segments of the gasket (81301) on threaded stud of the compressor cas-
ing (72000).
2. Attach the lifting gear to the front lug and rear eyelet of the filter silencer (81000).
3. Position filter silencer on compressor casing.
4. Fit nuts (72004) with washers (72003) and insulating discs (81302) and tighten.
5. Fit insulation ring (81300).
6. Fit air outlet silencer (74040) with gasket (74042) and secure with counter-sunk
screws (74043).
Fit insulation as far as necessary.
To Next Page
Loading...
