Operation Manual / TPS44-F.. - TPS61-F..
Maintenance 5
Cleaning components mechanically 5.4 Page 69
© Copyright 2016 ABB. All rights reserved.
August 2017HZTL2412_ENRevision F
Compressor-end, non-rotating parts
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or
contact with them may be harmful to health.
τ Do not breathe in these substances and avoid contact with the skin.
τ Ensure proper ventilation.
τ Observe the information in the material safety data sheet for the op-
erating materials and supplies.
τ Wear personal protective equipment (PPE) according to the material
safety data sheet.
τ Comply with local legislation.
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following performance-relevant parts can be cleaned according to the
following description.
72000 Compressor casing
77000 Wall insert
79000 Diffuser
τ Clean the components specified above with steam or allow to soak in
diesel oil or water with household detergent. After soaking, remove the
dirt with a brush.
τ Dry components completely.
τ Spray cleaned surfaces with penetrating oil. Do not spray the outer
surfaces of the turbocharger.
τ Dispose of dirty water and cleaning agent in accordance with the spec-
ifications in the safety data sheet.
5.4.3
To Next Page
Loading...
Need help?
General
