To Next PageTo Next PageWhy is there a reduction in speed in my ABB charger?
A reduction in speed in your ABB charger can stem from: * Defects of connected cylinders when pulse charging: Contact the enginebuilder. * Heavy contamination of the turbine: Clean it. * Damaged rotor components or bearing: Contact an ABB Turbocharging Service Station. * Defects such as leaks in the exhaust gas pipes or charge air ducts: Make repairs.
What to do if my ABB charger is surging?
If your ABB turbocharger is surging, it could be due to: * A contaminated or damaged guard in front of the turbocharger: Clean or replace it. * A contaminated filter silencer or diffuser: Clean it. * A contaminated cooler: Clean it. * A blocked charge air duct.
Why is the lubricating oil pressure too low in my ABB charger?
If the lubricating oil pressure is too low in your ABB charger, consider the following: * Oil filter heavily contaminated: Clean it. * Defective oil pump in lubricating system: Check or replace it. * Manometer display wrong: Replace the manometer. * Rotor axial clearance too large: Contact an ABB Turbocharging Service Station.
How to fix a sluggish start-up on my ABB charger?
A sluggish start-up in your ABB charger can be caused by: * A contaminated turbocharger: Clean it. * A damaged bearing: Contact an ABB Turbocharging Service Station.
Why is my ABB charger vibrating?
If you're experiencing vibrations in your ABB charger, it might be due to: * Rotor unbalance: Contact an ABB Turbocharging Service Station.
Why is there an increase in speed in my ABB charger?
An increase in speed in your ABB charger may be caused by: * A heavily contaminated nozzle ring (with 4-stroke application): Contact an ABB Turbocharging Service Station.
What causes fouling of the compressor in my ABB charger?
Fouling of the compressor in your ABB charger, due to the feeding in of ventilation gases, may result from: * Heavy fouling of the compressor components: Clean compressor. * Material of compressor wheel corroded: Check the fuel and its corrosive components, and change fuel if necessary.
Why is my ABB HT572308 Industrial Equipment vibrating?
Vibrations in your ABB Industrial Equipment can occur due to several reasons. It might be caused by rotor unbalance, in which case you should contact an ABB Turbocharging Service Station. Vibrations can also arise from a damaged turbine or compressor, or a damaged bearing.
How to deal with rubbing of rotating parts in ABB Industrial Equipment?
If you notice rubbing of rotating parts in your ABB Industrial Equipment, contact an ABB Turbocharging Service Station if there is any doubt about the extent of the rubbing. Also, have a dimension check carried out by an ABB Turbocharging Service Station.
How to fix sluggish start-up of ABB HT572308 Industrial Equipment?
A sluggish start-up of your ABB Industrial Equipment can occur if the turbocharger is contaminated. In this case, clean the turbocharger. Another possible cause is a damaged bearing. If the bearing is damaged, contact an ABB Turbocharging Service Station.
General| Breaking Capacity | 6 kA |
|---|---|
| Poles | 3 |
| Mounting | DIN Rail |
| Type | Circuit Breaker |
| Rated Voltage | 400V AC |
| Mechanical Life | 20000 cycles |
| Electrical Life | 10000 cycles |
