Need help?Do you have a question about the ABB PBA2 and is the answer not in the manual?
General| Device Type | Miniature Circuit Breaker |
|---|---|
| Rated Voltage | 230/400 V AC |
| Trip Unit | Thermal-magnetic |
| Breaking Capacity | 6 kA |
| Mounting | DIN rail |
| Standards | IEC 60898-1 |
Details the use of the condenser bushing potential device for securing power from high voltage lines.
Describes the weatherproof steel housing and internal components of the potential device.
Explains the device's Class 'A' performance and sensitivity to system frequency.
Explains the need for tuning the device to match bushing and burden, and required reference voltage.
Details the procedure for correcting the power factor of the burden to unity.
Covers the final adjustments for phase angle and voltage magnitude.
Details heater purpose and protective gap function, setting, and operation.
Describes operation at over voltages and why burdens are not fused.
Defines the maximum burden for the auxiliary winding terminals.
Lists record details and provides steps for adjustment troubleshooting.
Outlines basic maintenance requirements for the potential device.
To Next Page
