Need help?Do you have a question about the ABB REF615 ANSI 5.0 FP1 and is the answer not in the manual?
Standard installation method where the relay front is flush with the panel.
Installation method where the relay is partially recessed into the panel.
Semi-flush installation with a 25° tilt for improved viewing angle.
Mounting the relay in a standard 19" instrument cabinet.
Installation method for mounting the relay case directly onto a wall.
Method for integrating the relay into standard 19" equipment racks.
Standard installation method where the relay front is flush with the panel.
Installation method where the relay is partially recessed into the panel.
Semi-flush installation with a 25° tilt for improved viewing angle.
Mounting the relay in a standard 19" instrument cabinet.
Installation method for mounting the relay case directly onto a wall.
Method for integrating the relay into standard 19" equipment racks.
General| Rated Frequency | 50/60 Hz |
|---|---|
| Binary Outputs | Up to 8 |
| Device Type | Feeder Protection Relay |
| Version | 5.0 FP1 |
| Protection Functions | Overcurrent, Earth Fault, Thermal overload, Under/Overvoltage, Under/Overfrequency |
| Communication Protocols | IEC 61850, Modbus, DNP3 |
| Auxiliary Supply Voltage | 110-250 V DC/AC |
| Mounting | Flush mounting |
| Operating Temperature Range | -40 °C to +70 °C |
| Dimensions | 177 x 177 x 150 mm (H x W x D) |
| Housing | Plastic |
| Standard | IEC 60255 |
| Input Voltage | 110-240 V AC/DC |
| Enclosure | IP54 |
To Next Page
