ABB RE 54 - Object Control in the MIMIC View

14
1MRS750500-MUM
Feeder, Machine and Transformer Terminals
Operator’s Manual
RE_ 54_
The configuration has to contain the Logic Control Position Selector
function (COLOCAT) to allow LOGIC position to be selected with the
[R\L] button (refer to the CD-ROM Technical Descriptions of Functions,
1MRS750889-MCD).
rlconsq_b
Fig. 4.2.2.-1 Control position selection sequence when LOGIC position is
selectable (COLOCAT function used in configuration)
rlconsq3_b
Fig. 4.2.2.-2 Control position selection sequence when LOGIC position is not
selectable (COLOCAT function not used in configuration)
4.2.3. Object control in the MIMIC view
Objects can be controlled with the [select], open [O] and close [I] buttons (see table
below). A selected object remains highlighted until a control command is given or
the time-out has elapsed. The user can adjust the time-out in MAIN MENU/
Control/General/Select timeout.
DISABLED
mode
• DISABLED mode is enabled
LOCAL mode
• LOCAL mode is enabled
• REMOTE mode is disabled
REMOTE mode
• REMOTE mode is enabled
• LOCAL mode is disabled
Table 4.2.2-1 Control position button (Continued)
R
L
R
L
R
L
!
Local LogicDisabledRemote
Local DisabledRemote