GB
ATTENTION
Works at the 230 V mains may be carried out only by
authorized, skilled personnel.
The ABB memory touch controller STD-MTS is used to
manage electronic ballasts of a 0 - 10 V or 1 - 10 V control
input for the brightness control of fluorescent lamps.
The maximum number of connectable ballasts is specified
in the rating of the corresponding manufacturer. Relay load
must not exceed a maximum of 4 A (~ 10 ballasts).
An integrated surge limiter avoids the otherwise high ma-
king currents of the ballasts. If higher capacities are to be
controlled, an external contactor has to be provided.
ATTENTION
When working at the memory touch controller STD-
MTS, make sure that the device is isolated from the
230 V mains.
Important instructions
To Next Page
Loading...
