To Next PageTo Next PageWhat causes reduced fatigue strength in ABB TPS 48E01 compressor wheels?
Reduced fatigue strength of the compressor wheel and compressor blade failure in ABB Marine Equipment can be attributed to corrosion of the compressor wheel material. Check the fuel and its corrosive components, and change fuel if necessary.
Explains the manual's objective and scope for turbocharger users.
Describes the turbocharger's main components and their operational principles.
Defines the turbocharger's specific applications and operational limitations.
Provides guidelines for proper storage of turbochargers and spare parts.
Covers general information on safety, personnel competence, and design variants.
Explains the various symbols and key terms used throughout the manual.
Details the information presented on the turbocharger's rating plate.
Provides contact details for ABB Turbo Systems service stations.
Overview of safety responsibilities and potential residual risks.
States compliance of ABB turbochargers with EU directives.
Explains mandatory safety signs and required personal protective equipment (PPE).
Defines warning and caution symbols and their implications.
Identifies locations and handling procedures for warning plates.
Outlines essential practices for safe operation and maintenance.
Details various hazards including mechanical, noise, heat, and electrical risks.
Describes the turbocharger's tolerance to deflagration events.
Emphasizes the importance of periodic checks for pressure vessels.
Covers safety procedures and precautions for lifting turbocharger components.
Details critical aspects of oil supply, filtration, viscosity, and pressure.
Outlines necessary inspections before, during, and after commissioning.
Provides steps for recommissioning the turbocharger after a period of inactivity.
Discusses noise levels, measurement, and methods for reduction.
Covers routine checks, service intervals, and periodic inspections.
Provides guide values for component replacement based on operating hours.
Explains the speed measuring system and its components.
Details procedures for safely stopping oil-cooled and water-cooled turbochargers.
Introduction to maintenance tasks, differentiating cleaning and mechanical work.
Procedure for wet cleaning the compressor without disassembly.
Methods for cleaning turbine components during operation using wet cleaning processes.
Guidelines for manual cleaning of various turbocharger parts.
Lists causes and solutions for sluggish start-up, vibrations, and rubbing parts.
Explains causes, consequences, and remedies for turbocharger surging.
Addresses issues like low oil pressure, speed changes, and high exhaust gas temperature.
Covers noises during run-down and short run-down times.
Troubleshooting tips for the speed measuring system, including sensor issues.
Illustrates methods for suspending turbochargers during transport.
Lists the weights for different turbocharger models.
Step-by-step guide for safely removing the turbocharger from the engine.
Procedures and specifications for correctly installing the turbocharger.
General precautions, tool identification, and assembly device maintenance.
Provides weights for individual turbocharger components and assemblies.
Detailed instructions for dismantling and reassembling turbocharger components.
Measurement procedures and specified values for axial and radial clearances.
Explains how to measure radial clearances using feeler gauges.
Lists specified tightening torques for various screws and fasteners.
Procedures for shutting down the turbocharger and fitting a cover plate.
Measures for mothballing the turbocharger for short-term storage (up to 12 months).
Procedures for long-term mothballing of the turbocharger (over 12 months).
Information required when inquiring or ordering spare parts.
Exploded views of the turbocharger with numbered parts.
Exploded views of the cartridge group with numbered parts.
General| Brand | ABB |
|---|---|
| Model | TPS 48E01 |
| Category | Marine Equipment |
| Language | English |
