Analyzer
System Components
2 19
Intended Use: The i-STAT 1 Wireless Analyzer is
intended for use, together with i-STAT Cartridges,
by trained medical professionals.
Note: UL Certification UL File Number E470709 covers
the i-STAT 1 Wireless Analyzer and the Electronic
Simulator only.
Appendix 1: i-STAT 1 Wireless Analyzer Labels
Note:
Pictured below are the three different labels that the i-STAT 1 Wireless
Analyzer may have. This label can be found on the back of the analyzer.
Analyzers whose label contains a triangle in the upper right corner are referred
to as having Wireless Module FCC ID: PI405W (Firmware: 6.5.X.X/X.X,
where X is ≥ one digit). Analyzers whose label contains two blue triangles,
one in each of the upper corners, are referred to as having Wireless
Module FCC ID: YOPGS1500M without SHA-256 support (Firmware:
GEXPSX.X.X/MCUX.X). Analyzers whose label contains two orange
triangles, one in each of the upper corners, are referred to as having
Wireless Module FCC ID: YOPGS1500M with SHA-256 support
(Firmware: GEXPSX.X.X/MCUX.X).
Wireless Module FCC ID: PI405W
(Firmware: 6.5.X.X/X.X)
Wireless Module FCC ID: YOPGS1500M without SHA-256 support
(Firmware: GEXPSX.X.X/MCUX.X)
Wireless Module FCC ID: YOPGS1500M with SHA-256 support
(Firmware: GEXPSX.X.X/MCUX.X)
i-STAT 1
Downloader
Electronic
Simulator
i-STAT Printer
Martel Printer
See System Manual for instructions.
For in vitro diagnostic use.
i-STAT 1
Downloader/Recharger
i-STAT Cartridges
To Next Page
Loading...
