8
WEIGHING
Whenever possible, please allow the scale to warm up for several seconds after first
turning the power on so that the scale will function properly and accurately.
ERROR MESSAGES:
EEEE or Err-O = Overload
, Lob or LoBatt = Low Battery
WEIGHING PROCEDURES
1. Press [ON/OFF] to turn on the scale. The display will count down from “999999” to
“111111” and then “0” appear on the display.
2. Select the weighing unit by pressing [UNIT] button.
3. The selected weighing unit will be displayed on the cursor next to the weight value.
4. Start weighing. Make sure the display is “0”, if not press the [ZERO] button to zero the
scale.
5. If you are using a container or tray, place the empty container on the scale, wait for the
stability indicator to be displayed, press [ZERO], the display will read “0” with the tray
or container on top.
To Next Page
Loading...
