Abilica WinStride - Step 3: Attach Front Pole

10
Step 3
1) This step should be done by 2 persons.
2) Lift up cover on front pole (49) as in fig. (a), and connect data cable
(29 & 30) as fig. (b)
3) Mount front pole (10) on mainframe and tighten as fig. (c) by using
curved washer (6), spring washer (7) and hexagon bolt(9). Put down
cover (49) and tighten well on mainframe.
4) Mount left and right hand support bar (52L & 52R) on support tube
(12) by using curved washer (6), spring washer (7) and hexagon bolt
(9) as in fig.
9
7
6
10
49
Step-3
(a)
(b)
(c)
29
30
(x8)
C
M8*1.25*20L
D15.4*D8.2*2T
D22*D8.5*1.5T
52L
6
7
9
12