ABLE AP1200 - Command Summaries; Summary of Print Format Commands and Volatile Settings; Summary of Real Time Status Information

Ref: "ProgGuide1_7.docx" Page 25 of 26
Document Revision: “1.7”
Document Date: “11 Sep. 2013”
5 Command Summaries
Summary of Print Format Commands and Volatile Settings
Function
Command
Clear Print Settings and Buffer
(Select single width, single height, no underlining, no extra inter-
character space, and default HTAB positions)
ESC,”@”
CAN (real-time)
Font Mode, Double Height, Double Width, Underlining ESC,"!",n
Underlining only ESC,"-",n
Inverted Print Mode ESC,"{",n
Print positioning HTAB
ESC,"$",n1,n2
ESC,"\",n1,n2
Line termination
(and Paper Feed)
LF
CR
ESC,"J",n
ESC,"d",n
Dot Addressable (Bit) Graphics ESC,"*",..
Entering and exiting Spooling Mode ESC,"L"
FF
Extra inter-character and inter-line spacing ESC,” “,n
ESC,”2”
ESC,”3”,n
Set HTAB positions ESC,"D",..
Request Printer STATUS BYTE ESC,"u",n
ESC,"v"
GS,ENQ (real-time)
Select Barcode Size and Format GS,"H",n
GS,"h",n
GS,"w",n
Print Barcode GS,"k",..
Cutter Control (ATB102 with M-T102A only) ESC,"i"
ESC,"m"
Summary of Real Time Status Information
Information
How reported
Note
Mechanism Status GS,ENQ STATUS BYTE bit 1 (Set = Mech is Active)
Data Buffer Status GS,ENQ STATUS BYTE bit 2 (Set = Buffer is Empty)
Paper Out Status GS,ENQ STATUS BYTE bit 3 (Set = Paper is Out)
Spool Mode Status GS,ENQ STATUS BYTE bit 5 (Set = In Spool Mode)
Real Time Battery Voltage GS,”I”,15 Also In Self Test
Charger Status GS,”I”,15 Also In Self Test