EasyManua.ls Logo

ABLE AP1200 - Summary Of Non-Volatile Settings

ABLE AP1200
26 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ref: "ProgGuide1_7.docx" Page 26 of 26
Document Revision: “1.7”
Document Date: “11 Sep. 2013”
Summary Of Non-Volatile Settings
Setting
How set
How reported
Note
Firmware Version No. GS,”I”,3 Also In Self Test
Unit Serial No. GS,”I”,6 Also In Self Test
Save all configuration to Flash ESC,"X",48
Auto-Save config to Flash (Period) ESC,"X",52.. GS,”I”,52
Baud Rate, Parity etc ESC,”X”,4.. GS,”I”,4 Also In Self Test
LED patterns & LED Flash Period ESC,”X”,18.. GS,”I”,18
Sleep Period ESC,”X”,11.. GS,”I”,11 Also In Self Test
Sleep Period (In Spool Mode) ESC,”X”,50.. GS,”I”,50 Also In Self Test
Default to Inverted Print ESC,”X”,9.. GS,”I”,9 Also Coded In Self Test
Short Demo Message ESC,”X”,23.. Coded In Self Test
Suppress "?" on Rx Error ESC,”X”,9.. GS,”I”,9 Also Coded In Self Test
Split dots Printing (enable) ESC,”X”,9.. GS,”I”,9 Also Coded In Self Test
Split dots Printing (MaxDotsAtOnce) ESC,”X”,33.. GS,”I”,33 Also Coded In Self Test
Sleep without Buffer Purge ESC,”X”,9.. GS,”I”,9 Also Coded In Self Test
Disable Feed Switch ESC,”c5”.. Coded In Self Test
Disable Demo Mode ESC,”c5”.. Coded In Self Test
Swap '#' (23H) <-> '£' (9CH) chars ESC,"X",23,n GS,"I",23
Use 'ø' & 'Ø' <-> '¢' (9BH) & '¥' (9DH) ESC,"X",23,n GS,"I",23
Use 'Ç' <-> '€' (80H) ESC,"X",23,n GS,"I",23
Use Code Page 1252 ESC,"X",23,n GS,"I",23 Also Coded In Self Test
Enable Black Mark Operation ESC,”X”,19.. GS,”I”,19 Also Coded In Self Test
Black Mark parameters (detail) ESC,”X”,20.. GS,”I”,20
Black Mark parameters (more detail) ESC,”X”,42.. GS,”I”,42
Paper Out -> LED Pattern ESC,”X”,19.. GS,”I”,19 Also Coded In Self Test
Head Up -> LED Pattern ESC,”X”,19.. GS,”I”,19 Also Coded In Self Test
Select Busy on Paper Out condition ESC,"X",23,n GS,"I",23
Font Mode ESC,"!",n Also Coded In Self Test
Disable FontMode changes ESC,”X”,9.. GS,”I”,9 Also Coded In Self Test
AUTO_STATUS settings GS,”a”..
A simple Windows setup program is available from Able on request, and when connected to a printer
with a suitable data cable, gives easy access to the settings in the tables above.
Please refer to Able Systems or visit our website at www.able-systems.com for more information.
You are always welcome to contact Able Systems or your local supplier for specific assistance.
We would also appreciate reports of any errors in our documentation, or suggested improvements.
Copyright © Able Systems Limited 2013. All Rights Reserved
[End]

Related product manuals