Abode RF User Manual

1. Function Button/LED Indicator
• Press and hold for 10 seconds to enter the pairing mode when learning it into the gateway.
• LED flashes once: When the button is pressed
• LED continuous flash: The Siren is under pairing mode or the system is in the alarming mode
abode Indoor Siren (abode RF)
Siren - User Guide
1
Introduction
The abode indoor siren is AC Powered with a rechargeable battery. It is capable of sounding its 95dB siren
when the abode alarm system is activated. It can be plugged into any indoor AC power outlet.
2. Alarm Volume and entry exit beep sounds (Refer to page 4 & 5)
• Alarm siren volume: Is not adjustable
• Entry / Exit / Arm / Home Arm / Disarm (These Sounds (Beeps) are defaulted to OFF. User
controllable from web app, under the account tab on the left / system settings.
3. AC Connect (Plug into local wall AC outlet)
Power Supply
The Siren is powered by AC power; plug the Siren into a power outlet to activate the Siren. The Siren will
enter normal operation mode.
Battery backup
There is a rechargeable battery inside the Siren that serves as a backup in case of a power failure. During
normal operation, AC power is used to power the Siren and at the same time recharge its battery.
After AC power failure, the battery will provide power to the siren for 12 hours, then transmit a Low Battery
signal to the gateway and send notifications. After AC is restored and battery is fully recharged, the Siren will
transmit a low battery restored notification to the gateway.
abode Systems Inc. Visit our support page for more information http://support.goabode.com/ 2016
abode reserves the right to update this product information at any time without notice.

Abode RF Specifications

General

Brand	Abode
Model	RF
Category	Security System
Language	English

Summary

Introduction to the Abode Indoor Siren

Function Button and LED Indicator

Details the function button and LED behavior for pairing and status.

Alarm Volume and Entry/Exit Beep Sounds

Explains siren volume and configurable entry/exit beep settings.

AC Connection and Power Supply

Covers connecting the siren to AC power and its battery backup functionality.

Pairing the Siren with the Gateway

Adding the Siren via Web App

Steps to add the siren through the abode web application.

Siren Pairing and Confirmation

Detailed steps for pressing the button and confirming pairing with the gateway.

Troubleshooting Siren Pairing

Instructions for re-pairing if the siren does not connect successfully.

Abode Indoor Siren Features and Controls

Alarm Activation and Audio Status

How the siren activates during alarms and its audio status indications.

System Status Beep Sounds

Different beeping sounds to distinguish various system statuses.

Door Chime Sound Configuration

How to control door chime sounds via the web app settings.

Controlling Siren Notification Beeps

Entry and Exit Delay Beeping Sounds

How to configure entry and exit delay beep sounds for the siren.

Final Beeps for Delay Countdown

Setting up final beeps at the end of entry/exit delay countdowns.

Confirmation Beeps Control

How to control confirmation beeps when the system is armed or disarmed.

Factory Resetting the Siren

Reset Procedure

Step-by-step instructions to reset the siren to factory default.