EN
10
Maintenance
Daily Maintenance
• Regular comprehensive cleaning will extend the life of your WalkSlim 810.
• Always turn the power off at the power outlet and make sure there is no moisture
before daily cleaning and maintenance.
• Clean dust out regularly and ensure the exposed parts of the tread belt are clean.
• Wear clean sports shoes to avoid any dust or impurities getting into the tread belt
and board.
• Use a damp cloth with soap or detergent to clean the tread belt. Do not use
excessive water and avoid leakage to the electrical components and underneath the
running belt
• Disconnect the power cord when the WalkSlim 810 will not be used for a long time.
• Do not store the treadmill in the bathroom or outside and avoid areas with a lot
of moisture.
Tread Belt Adjustments
While each treadmill tread belt has been finely adjusted, after transport and installation
it may need to be adjusted. Adjustment may also be required throughout the life of the
treadmill. Reasons for this may be:
1. The treadmill has been on an uneven surface.
2. When in operation, the user walks / runs unevenly (to one side) on the belt.
3. The users on the treadmill have different physical weight and force.
Tread belt deviations will seriously damage the tread belt and must be found in time and
corrected.
NOTE: Correct maintenance of the treadmill is important and issues arising from
ongoing tread belt misalignment will not be covered under warranty.
How to adjust alignment on left side: tighten
the bolt (clockwise) on the left side if the belt is
deviating to left side or loosen bolt on the right
side (counter clockwise).
How to adjust alignment on right side:
tighten the bolt (clockwise) on the right side if
the belt is deviating to right side or loosen bolt
on the left side (counter clockwise).
To Next Page
Loading...