EN
13
The belt is
running to the left
1. Tighten the bolt clockwise on the left side or loosen bolt on
the right side counter clockwise using the Allen Key.
2. Start the WalkSlim 810 to check the new position of the belt.
3. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
4. After adjusting the belt to the middle, start the WalkSlim 810
for 1-2 minutes and observe the tread belt to ensure that
is running smoothly. If it’s not centralised, then repeat the
adjustment steps again.
The belt is
running to the
right
1. Tighten the bolt clockwise on the right side or loosen bolt on
the left side counter clockwise using the Allen Key.
2. Start the WalkSlim 810 to check the new position of the belt.
3. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
4. After adjusting the belt to the middle, start the WalkSlim 810
for 1-2 minutes and observe the tread belt to ensure that
is running smoothly. If it’s not centralised, then repeat the
adjustment steps again.
The belt is
skidding
• Turn the left and right screw half a turn clockwise at the same
time and then repeat the adjustment until running normally.
Do not tighten the screw excessively.
To Next Page
Loading...