UK
32
4.3/ JUMPSTARTER /Start Assist
Comment: The Start Assist procedure must be followed strictly per the instructions below:
- First, use “BOOST”, the quick battery charger, for 10-15 min.
- Place the red cable on the 12V or 24V terminal of the charger depending on the desired voltage and tighten the nut
firmly.
- Connect the red (+) clamp of the charger to the red (+) terminal of the battery.
- Connect the black (-) clamp of the charger to the ground closest to the starter.
- Connection points must be away from the fuel hoses.
- Position the main switch on "O”
- Plug in the 220V power cord.
- Position the switch on "START".
To Next Page
Loading...
