BEEP!
BEEP!
2x
BEEP!
BEEP!
2x
10s
5
7
4
6
Trigger the tamper contact
of the detector or send a
signal from the detector.
Once the signal has been
received, the universal
module will assign a new
channel to the detector in
question.
The LED corresponding to
that channel will start to
ash. Once the detector
has been taught-in
successfully, the universal
module will beep twice.
Once all detectors
have been taught-in,
press the 'ESC/DEL'
button twice and the
universal module
will beep at short
intervals.
Repeat step 2.4 to teach-in
additional detectors.
Please note that the detectors, which you have learned in the WAM,
have also to be taught in the Secvest.
Hold the tamper
contact down for
about ten seconds
– two beeps will be
heard.
Teaching-in the universal
module on the SECVEST
alarm panel
OPTION 1
2
1
Teaching-in on
the SECVEST panel:
Wählen Sie -> Errichtermenü
-> Komponenten -> UVM ->
Hinzufügen/Entfernen UVM
Select a storage location with
available space and conrm
your choice by pressing
'Select'.
Trigger the tamper contact of
the universal module – the
alarm panel will audibly
conrm receipt of the message.
Close the
universal module
housing and exit
installer mode.
To Next Page
Loading...