Abus HomeTec Pro - Battery Replacement; Tecnical Data; Tips for Troubleshooting

30 31
6.
Battery replacement
aprox. 3 sec. - 10 sec.
AA
+
-
A
B
1.
2.
3.
automatic calibration run

First remove the four batteries and
then insert four new batteries / accus

AA
+
AA
+
6.1 b 6.1 d
-
A
B
1.
2.
6.1a 6.1b
6.1d
4x
AA
+
ACCU
+
ready
to
use
6.1c
6.1e
+
-
+
-
+
-
Tips for troubleshooting
7.
Fault / information Cause Solution




process and a
sustained acoustic
signal sounds
The door was not closed
during the second part
of the teach-in process

process and close the

time

during normal
service and a
sustained acoustic
signal sounds
- The door is not closed
during operation so
the drive pushes the
door bolt against the
door edge
or
- at least one battery is
inserted the wrong
way round
or
- the locking mechanism

calibrated incorrectly
- Close the door and
repeat operation
- open the battery
compartment and
check the polarity of
the batteries/insert
the batteries correctly
>> 6.
- set the door correctly

mechanism
An acoustic signal
sounds before
every rotational
movement by the
drive
The batteries are dead Change the batteries
>> 6.
Before opening the
door, the drive
carries out a refe-
rence movement
The door has since been
manually opened/closed
using a key or the drive’s
handwheel has been
turned
No action is required.
A reference movement is
necessary to identify the

drive has been manually
turned using a key from
outside or the hand-
wheel from inside.
Tecnical data
Dimensions 138 x 52 x 65 mm
 418 grams
IP class IP 20
Battery type 4 * AA 1,5 V alkaline
Operating temperature range 0°C to +40°C
 
Max. radiated transmission power < 10dBm eirp
 
8.