3 4
4. Adjustment of the straps
tautly and comfortably beneath the ears.
prevent accidental displacement.
Make sure the chin-guard, which must be locked before every ride, doesn’t lie on the
Should the straps be too long, please cut them down to the required length and seal the
5. Proper maintenance and care
• Regularly check the helmet for signs of damage.
• Do not apply stickers or paint to the helmet as this can be damaging to the materials.
• Do not remodel or misuse the helmet.
damage, please purchase a new helmet.
• This helmet has a limited service life and should be replaced when it shows obvious
signs of wear.
-
production date even if it displays no clear visible or technical defects
• The helmet, inner pads and head ring can be cleaned using lukewarm water,
• The LED rear light does not replace the statutory lighting installation requirement
for bicycles.
• Only use original spare parts.
following standards:
• 89/686/EWG: Guidelines for personal protection equipment
• EN 1078:2012+A1:2012 – European standard for cyclists, skateboarders and inline skaters
Attention: Please note that no helmet is indestructible and will not prevent all
head injuries.
For the best possible protection, please observe the following guidelines:
1. Usage
Attention: Please note that it is necessary for children to remove their helmets before
entering playgrounds. This helmet should not be used by children while climbing or
doing other activities when there is a risk of strangulation/hanging if the child gets
trapped with the helmet.
2. Optimum fit
horizontally on your head.
• Do not pull the helmet over your forehead, reducing visibility.
• Do not push the helmet towards the back of your head, as this will not protect
your forehead.
3. Adjustement of the head ring
Almost all ABUS helmets are available in 2 sizes.
Adjusting the helmet to the individual head size
can be achieved, depending on the type, with the
EN 1078:2012+A1:2012
ABUS_Helmets_MA_148x105mm_Pedelec_RZ_160823.indd 3-4 04.01.17 08:33