40
IV. Fitting tools
• Phillips screwdriver
• Drilling machine for wood, metal and walls
• Mechanic‘s level, metering rule
• Metal saw, file
• Tools for additional work are not included in this installation
V. Replacing the door cylinder
If the door cylinder does not need to be replaced, continue to read under chapter VI.
Warning: The VdS recognition only applies in connection with the use of a VdS class A or a
higher class of door cylinder.
With door leaf strengths above 50 mm and/or if the door cylinder has to fit in a locking
system, the standard door cylinder must be replaced.
The same applies if it is set to be fitted without any “option to lock from outside”.
1. New door cylinders correspond to DIN EN 1303/DIN 18252 and obtain spacers and longer
screws if required:
• With door leaf strengths greater than 50 mm: Obtain door cylinders of a greater length
(see tab 1), as well as spacer and longer screws if required
• Use the door half-cylinder 10/30 during fitting without the possibility of closing from
the outside
Door panel
thickness
in mm
1
1
1
1
1
1100
1110
30/60
30/70
30/80
30/90
30/100
30/110
30/120
1
2
3
4
5
6
enclosed
enclosed
enclosed
M6 x 60
M6 x 60
M6 x 70
M6 x 70
Cylinder dimensions in mm
(Dimension inside/Dimension outside)
Spacer discs with a thickness
of 10 mm, Quantity
Screws DIN 7988.8
in mm
Table 1
To Next Page
Loading...
