– 28 –
When marking out your drill holes, ensure that no electrical wires/cables,
pipes or other installation components are located behind the installa-
tion point!
4. Then enter the current date (installation
date) on the label on the reverse side
of the alarm with a water and abrasion
resistant pen (see illustration opposite).
5. Attach smoke alarm by turning clock-
wise at the unit base.
6. Remove the locking pin located in the mounting socket and insert it into the
designated side opening to prevent the alarm from turning (see illustration
below).
Installation and operation
Installationsdatum | Installation date | Date
dínstallation: ___________________ DD|MM|YYYY
z.B.: 09/05/2014
Insert xing plugRemove the xing plug with screwdriver
To Next Page
Loading...
