33
English
5
If you wish the address data to
be automatically assigned, tick
the “Enable DHCP” checkbox. The
addresses will then be automatically
assigned by your router (where
supported). If proceeding in this way,
move on to point13.
6
If your router does not automatically
assign the address data, enter the data
according to the following steps.
The image gives an example
of connected devices with the
corresponding IP addresses.
192.168.0.1
192.168.0.25192.168.0.20
4
Set the connection speed for
“NIC Type” manually. Automatic
detection is preset and recommended
(self-adaptive).
To Next Page
Loading...
