AC Infinity SUNCORE - PROGRAMMING SETTINGS: DISPLAY AND UNITS; Controller Settings Overview; Display Brightness and Dimming; Fahrenheit;Celsius Unit Selection

24
PROGRAMMING
F/C SETTING
In this setting, change the displayed units to Fahrenheit
or Celsius. Press the up or down button to cycle through
F and C. All displayed units on the controller will change
automatically with your setting.
DISPLAY SETTING
In this setting, adjust the brightness of the display and
auto-dimming. Press the up or down button to cycle
through 1, 2, 3, A2 and A3. The highest brightness is 3
while the lowest brightness is 1. The settings 1, 2, and 3
are not auto-dimming, and the display will continuously
be shown at that brightness level. In A2, the display
will be shown at brightness 2 but fall to brightness 1
whenever the controller is not being adjusted after 15
seconds. In A3, the display will be shown at brightness
3 but fall to brightness 1 whenever the controller is not
being adjusted after 15 seconds.
CONTROLLER SETTINGS
Pressing the setting button will cycle through the controller’s available settings: DISPLAY, F/C,
CLOCK, CALIBRATION TEMPERATURE, CALIBRATION HUMIDITY, BUFFER TEMPERATURE,
and BUFFER HUMIDITY.
DISPLAY
PM
°F/°C
PM